MDI Pump Up A Tank Control Float 1/2HP 230V
Pump Up and Pump Down Control Floats<< Back
Pump Up Float w/10' cord 230V piggyback plug (yellow-used when automatic filling of a tank is desired)
Normally Closed Contacts When Hanging Down
NOTE: A float weight should be used instead of a wire tie. Wire ties don't do well when submersed underwater for long periods of time and have caused many failures. When using a float weight the cord must be retained at the top of the tank.
NOTE; THESE FLOATS HAVE PIGGYBACK PLUGS. THE PIGGYBACK PLUG MALE SPADES PLUG INTO THE WALL AND THE FEMALE SOCKETS ACCEPT THE PLUG OF THE CONTROLLED DEVICE. THE PLUG CAN ALSO BE CUT OFF EXPOSING 2 WIRES WHICH CAN THEN BE HARD WIRED AS A SINGLE POLE SWITCH USED IN SERIES FOR UP TO 13AMP.
Product Q & A