EK Shallow Well Jet Pumps

In-Stock and Free Shipping

Go to EK Shallow Well Jet Pumps on F&W's website.

*** Looking for a lower cost Shallow Well Jet Pump? ***

Features and Benefits

EK Jet Pumps: Includes pump with *built-in shallow well ejector, motor and pressure switch

Designed for shallow wells with suction lifts from 0′ to 25′ (0 – 8 m). These pumps provide capacities up to 1200 GPH (4,542 LPH) and pressures up to 50 PSI.

EK models feature the famous Flint and Walling “Service Plus” motor, available with Uni-frame flange construction. The F&W 56 frame, double ball bearing motor offers the ultimate in performance and dependability.

Designed for years of trouble-free operation and simple, swift, on-site servicing, EK models feature unique interchangeability of replacement parts to keep inventories at a minimum.

Suction lift: 0′ to 25′ (0 – 8 m)

Notes: EK05S and EK07S feature built-in ejector – no assembly required. EK10S ejector requires some assembly.

Product Specifications

• Pump Material: Cast iron pump and motor housing for long life
• Impeller Material: Plastic
• PH: 1PH
• HP: 1/2, 3/4 or 1
• Volts: Dual Voltage 115/230V with easy change voltage switch
• HZ:: 60HZ
• Motor Enclosure: ODP
• Suction/Discharge Pipe Sizes:  Female NPT: 1-1/4"FNPT X 1"FNPT

EK Shallow Well Jet Pump Parts

Flint & Walling Shallow Well Jet Pump w/integral Jet Repair Parts "E" Series     

Purchase EK Shallow Well Jet Pump Parts

Technical Data

EK Performance Chart

EK Shallow Well Performance Chart

EK Shallow Well Jet Pump Instruction Manual

EK Shallow Well Jet Pump Instruction Manual

EK Shallow Well Jet Pump Capacities

Flint & Walling's EK Shallow Well Jet Pump Brochure

EK Shallow Well Jet Pump Specifications

Flint & Walling's EK Shallow Well Jet Pump Specifications

EK Shallow Well Jet Pump Service Plus Motor

EK "Service Plus" Motor

Jet Pump Not Producing Pressure Like it Use to?

Is your jet pump not producing the pressure it used to? In the front on most shallow well jet pumps and deep well jet pumps with shallow well adapters there is a 1/4" pipe plug located in the front of the pump or shallow well adapter where the center of impeller would line up (usually right below the suction pipe). Remove that 1/4" plug and make sure the jet is open and not plugged. This is a common occurrence and by cleaning this jet from being restricted or plugged can renew your jet pumps pressure.