Franklin SubDrive 20 VFD Controller NEMA3

FREE GROUND

In Stock for Next Day Shipping Upgrade $99

Looking for a Lower Cost, Fully Interchangeable, American Made with Menu, Plug and Play, 2HP Controller Kit with Pressure Switch? (NEMA 3R for indoor/outdoor use) Click Here - VS20 Controller Kit Complete with Pressure Switch

Questions??? 866-960-9621 David 

Features

SubDrive20 (NEMA-3R) (Indoor/Outdoor Protection)

Product number: 5870205313C

Input from power source:  

• Phase In:
  • 1 Single-phase
    • Input Volts: 208-230v
    • Frequency: 60-50HZ
    • Current (max): 19A
    • Power (idle) 5 watts
    • Power Factor -0.95
    • Power (max) 4.2 kW
    • Wire gauge size(s): (Consult Federal, State and local codes for branch circuit installations
  • Output Power:
    • Voltage: Adjust with Frequency
    • Phase Out: Single-phase (3-Wire) OR Three-Phase
    • Frequency Range: 30-78 Hz (1HP, 0.75 kW) pump
    • 30-72 Hz (1.5HP, 1.1 kW) pump
    • 30-60Hz (2HP, 1.5 kW) pump
    • 30-63HZ (Single-phase motors)
    • Current Max: 8.1A / phase
    • Wire Gauge Size: #6 Awg. - #14 Awg. - Refer to Franklin Installation SubDrive Manual
  • Pressure setting: Factory Preset 50psi (3.4 bar), Adjustment Range 25-80 psi (1.7 - 5.5 bar) (Pressure sensor included)
  • Operating Conditions: (at 230 VAC Input): -13° F to 122° F (-25° C to 50° C)
  • Relative Humidity: 20-95%, non condensing
  • Controller Size:: 9-3/4" X 19-3/4" X 5-1/4" (25x50x13 cm)
  • Weight: 26lb. (11.8 kg) (approximate)

For use with: Pump 60hz (if a pump other than the default rating is used, refer to drive configuration):

• 1HP (0.75kW) pump with 214508-series motor - single phase, 3 wire
• 1.5HP (1.1kW) pump with 224300-series motor - single phase, 3 wire
• 2HP (1.5kW) pump with 224301-series motor - single phase, 3 wire
• .75HP (0.55kW), 1HP (0.75kW) or 1.5HP (1.1kW) with 234514-series motor - three phase
• 1HP (0.75kW), 1.5HP (1.1kW) or 2HP (1.5kW) with 234315-series motor - three phase