F&W 2HP 230V 3W Submersible Motor

F&W 3 Wire Submersible 4" Motors

<< Back

F&W 2HP 230V 3W Submersible Motor

SKU: 3894

Quantity: Free Ground Shipping

Flint and Walling Products IN-STOCK with FREE SHIPPING

Flint & Walling Family Owned American Proud

Features and Benefits

  • Nitrile Rubber Shaft Seal. Three-part design protects motor from contamination.
  • 17-4 Stainless Steel shaft. Features polished bearing journals for extended bearing life.
  • 304 Stainless Steel Stator Liner.
  • Stainless Steel Carbon Graphite Kingsbury Thrust Bearing. Provides self-aligning axial support up to 650 lbs. for reliable operation.
  • 301 Stainless Steel Shell and 304L Stainless Steel Stator Ends. Hermetically sealed for maximum corrosion resistance.
  • Carbon Graphite Radial Bearings. Precision ground for high load capability and long life.

100% Factory Tested

  • Stator hi-pot, resistance, surge.
  • Weld quality
  • High pressure motor integrity verification.
  • Final motor hi-pot, no load, and maximum thrust load.
    • Drinking water NSF/ANSI 61
    • Max Water Temp 86 degrees F without need for flow inducer sleeve.

Description: (3) wire motors have 3 lead wires for power and 1 ground wire. Lead wires are included with all F&W submersible motors. Specs. for 3 wire motor leads are 14/2 Awg. and are 48" long.

F&W motors are built to NEMA 4" submersible motors specifications and interchange with other makes such as Franklin, Pentek, Centri-Pro and Grundfos motors built to NEMA standards for 4" submersible motors.

Product Specifications

1/2HP to 1-1/2HP 3 wire F&W submersible motors have internal overload protection built in.

  • HP: 2
  • Volts: 230
  • KW: 1.5
  • HZ: 60
  • Amps: 11.4
  • Watts: 2380
  • SF: 1.25
  • S.F. Amps 13.2
  • S.F. Watts: 2800
  • Winding Ohms: Yellow to Black: 1.7 to 2.2, Yellow to Red 7.8 to 9.6
  • LR Amps: 52
  • KVA Code: J
  • Model 137435

Technical Data

Submersible Motor Data

Single Phase Motor Fuse Sizing: 30amp Breaker, Standard Fuse: 40amp or dual Element Time Delay Fuse: 20amp.

Submersible motors should not be cycled on and off in excess of 1 time in 5 minutes and be limited to 25-50 starts in 24 hours.

A (3) wire submersible motor requires a minimum of 10 seconds between starts for the internal start/run switch to reset.

Engine driven generator requirements - External Regulated: KW: 7.5, KVA: 9.4 - Internally Regulated: KW: 4.0, KVA: 5.0

Note: Generator should always be running before motor connected. Before stopping a pump, shut off pump before turning off generator. Most generators today are of the external regulated type. Internal regulated generators have an internal winding and it controls the output current.

Product Reviews Write A Review


No reviews yet, be the first to review this product!

Product Q & A