EK05S 1/2HP Shallow Well Jet Pump

EK Shallow Well Jet Pumps, Parts, and Motors

<< Back

EK05S 1/2HP Shallow Well Jet Pump

SKU: 4402

Quantity:
IN STOCK
Factory Fresh Warranty
Free Ground Shipping

Questions? 866-960-9621

   

  

Flint & Walling Products IN-STOCK & SHIPS FREE!

Flint & Walling Family Owned American Proud

Features and Benefits

A Flint and Walling EK05S shallow well jet pump is a device that uses a jet of water, creating a vacuum and high velocity, which creates higher inlet pressure into the impeller, and creating higher outlet pressures, when drawing from a water source. Designed for shallow wells with suction lifts to surface of water down to 25′. The pump has a 1/2 HP Service Plus (exclusively manufactured in America by Flint and Walling) motor that runs at 3450 RPM and can be powered by dual voltage (115 or 230 volt), with capacitor start. It comes with an Automatic, start and run overload, to ensure complete winding protection. It can deliver up to 5.8 GPM @ 40 PSI of water at pressure up to 60PSI in shallow well applications (please see chart for shallow well performances). It has a cast iron body, a thermoplastic impeller, and a silicone carbide seal. It comes with a pump, a motor, and a pressure switch. It is designed for easy priming, high performance, and long-lasting durability. It has a one-year limited warranty from the manufacturer.

Technical Data

Model Comparison Charts

Motor Specification Chart, EK Convertible Jet Pump Series, 60hz

Product Specification Chart, EK Convertible Jet Pump Series, 60hz 

Pump Performance Charts

Performance Chart, EK Shallow Well Capacities

Catalog:

FW0180, CPJ CPH EK FJ Catalog, 60hz

Technical Support

020183, Convertible Jet Instructions, 60hz

EK Series Repair Parts

Is your Shallow Well Jet Pump Not Producing Pressure Like It Used To?

Is your jet pump not producing the pressure it used to? In the front, on shallow well jet pumps and deep well jet pumps with shallow well adapters (as seen in picture below pump), there is a 1/4" pipe plug located in the front center of the pump or shallow well adapter, where the center of impeller would line up (usually right below the suction pipe). Remove that 1/4" plug and make sure the jet is open and not plugged. This is a common occurrence, and by cleaning this jet from being restricted or plugged, can renew your jet pump pressure without the disassembly of the pump. Find an example in the pictures below.

Flint & Walling Plugged JetFlint & Walling Open Jet 

Product Reviews Write A Review

Comments

No reviews yet, be the first to review this product!

Product Q & A